Ukrola njani iipateni ezigqwesileyo kwindebe yeThermos

Ukuba umthengi ukunika ikomityi ye-thermos kwaye ufuna ukuba ukrole uphawu lwenkampani kunye nesilogeni kwikomityi ye-thermos, ngaba ungayenza ngeemveliso onazo ngoku?Ngokuqinisekileyo uya kuthi ewe.Kuthekani ukuba bafuna ukukrola iipateni ezigqwesileyo?Ngaba ikho indlela yokuphumeza isiphumo esingcono sokumakisha?Masiyiphonononge kunye.

Misela iimfuno kunye nomthengi ngaphambi kokuba kuqhutywe

•Ayonakalisi i-substrate

•Gqibe ngexesha elinye, kokukhona kungcono

• Susa ipeyinti efunekayo ukuze kugcinwe intsimbi

•Ukumakishwa komzobo kugqityezelwe ngaphandle koguquko kwaye umzobo awunamagqabaza okanye imiphetho ejijekileyo

Emva kokuqinisekisa iimfuno, iingcali ze-FEELTEK zamkele isisombululo esilandelayo sokuvavanya

Isoftware: LenMark_3DS

ILaser: 100W CO2 laser

I-3D Dynamic Focusing System: FR30-C

Ummandla oSebenzayo: 200 * 200mm, Z ulwalathiso 30mm

Ngethuba lenkqubo yokuvavanya, ochwepheshe be-FEELTEK beza kwizigqibo kunye neengcebiso ezilandelayo

1. Ukuba akufunwa ukulimaza isinyithi, sebenzisa i-CO2 laser.

2. amandla e-laser akufanele abe phezulu kakhulu xa ususa ipeyinti ekugqithiseni kokuqala.Amandla agqithisileyo aya kubangela ukuba ipeyinti ivuthe lula.

3. I-Edge jaggedness: Le ngxaki inxulumene ne-angle yokuzalisa kunye nokuzaliswa koxinaniso.(Ukukhetha i-engile efanelekileyo kunye nokuzalisa i-encryption yoxinaniso kunokusombulula le ngxaki)

4. Ukuze kuqinisekiswe umphumo, ekubeni i-laser iya kuvelisa amalangabi kunye nomsi kwindawo yepeyinti (i-graphic surface iya kuba mnyama), kucetyiswa ukuba kusetyenziswe umoya wokuphefumula.

5. Umba wemfuno yexesha: Kucetyiswa ukuba amandla e-laser abe malunga ne-150W, kwaye isithuba sokuzalisa singandiswa.

Ngexesha lenkqubo yokuvavanya kamva kwabanye abathengi, i-FEELTEK iphinde iphumeze imizobo emikhulu kunye neyinkimbinkimbi kwilabhoratri.